Infresco 1.5kW control

INFRESCO 1.5kW control is a variable regulator controller available in 2 versions. Either a 5 step (Off / Low / Medium / High / Full) version or a fully variable output version, both offer control of mains-driven loads, specifically Quartz Halogen Infrared heat lamps, rated up to a total of 1.5kW.
This microcontroller-based unit incorporates a ‘soft-start’ gradual switch on function to eliminate the lamp’s initial high inrush current – potentially increasing the lamp life by as much as 30%.
Output levels are selected by up & down push-buttons with a high-intensity LED indicating when the controller is regulating the power to the lamp load.
A relay override function is built in the circuit design – thus, at maximum power (100%), the relay ‘switches in’ and bypasses the power (triac) and suppression (choke) devices. This helps to keep the units heatsink temperature to a lower operating temperature, since they are not in use in this state and generate no heat. Normal control is resumed below approximately 96% of the power setting.
Installation is simple and once installed is very low maintenance

5 STEP OUTPUT – Off / Low / Medium / High / Full

Output levels are selected by up & down push-buttons with a high-intensity LED indicating
when the controller is regulating the power to the lamp load.

Typical applications are Pub Patio areas, Smoking Shelters, Restaurants, Warehouses, Work shops.
FEATURES
 Simple Wall Mounting
 IP55 protection for outdoor installation
 Soft-Start function
 Simple In-Line wiring, via 3-core cables
 Pre-selected heat output levels for optimum comfort control
 Power output indication
 Integral EMC filter suppression
 Relay override at maximum output – minimizing heat dissipation